Paralleling two LP2981 to select two voltages

National Semiconductor, The Power of Analog

This Discussion Forum is provided by National Semiconductor as a medium to allow engineers share their technical knowledge and experience. Questions and comments posted here are visible to all members of this website. Anyone can post questions or comments as well as responses as long as they are are registered on 'NATIONAL.COM'. As this is an engineer to engineer discussion forum, National Semiconductor assumes no responsibility for the accuracy of the information provided.

Start Here

Community Discussion Message Details

Create New Message
Reply to "Paralleling two LP2981 to select two voltages"

ignacio
on 09/30/2008 at 02:12 PM

Category(s):	Technical Questions, power.national.com
Subject:	Paralleling two LP2981 to select two voltages
Message: (Notified via email on every direct response)
Dear sirs: I'd like to know if it's possible to connect in parallel two LP2981's of diffrent voltages in order to change (using both enable pins) the output voltage of that regulator block. The Vin and Vout of both regulators being in parallel, Vin the same for both regulators and the same source. Thanks in advance

Navigation

Previous Main |Next Main

main message &
.. replies:

Paralleling two LP2981 to select two voltages (ignacio)
. . Re: Paralleling Two LP2981 LDOs (fred.embuscado - national.com)

View

Community Search

Please enter search terms below:

e.g.: power, use 'and', 'or' & wildcard '*' to narrow search